ALL IN ONE GY6 Manifold riser angled clocking flange 56mm V3 NO CUTTING PLASTICS

The GY6 Intake Manifold Riser and angled clock flange all in one is here! V3 NOW COMES IN 30MM JUST IN CASE YOU HAVE A BIG BORE HEAD.  No more 2-piece setups that need a gasket to seal.  This Intake Manifold Riser can help you get a better fitment! This will give you all the clearance you need so you can run a forward-facing carb WITH THE CORRECT ANGLE and clears the cross-member bar!  The best part yet is now you don’t have to cut the plastics!

Includes All Stainless-Steel hardware the GY6 head only and for the GY6 manifold! Also included is Gasket instead of O-Ring. We HIGHLY recommend you use PEMATEX ULTRA BLACK RTV (ULTRA DOES NOT BREAK DOWN WITH GAS) on the gasket. FILL in O-Ring area with RTV and BOTH sides of the gasket install and let fully cure before test ride. This is for 28mm or 30mm manifolds only.

• M6X55 CONNECT FLANGE TO HEAD. We recommend removing the black plastic piece on the head it’s just 1 more spot for a vaccum leak. If you choose t use it you will need to order longer M6X60MM Socket Cap x 2
• 6X40MM ARE TO CONNECT 28-30MM AFTERMARKET MANIFOLD TO CLOCKING FLANGE.
• Made in USA from 6061-T6 Aluminum