150cc 4-Stroke Long-Case GY6 Gas Engine with automatic CVT transmission.
Comes with 11 pole stator and flywheel installed in house. Also 8mm NCY Studs and Exhaust Nuts.
No need to buy upgraded stator or flywheel puller saves you time and $$.
This complete engine includes electric starter, kick start, and BLACK CVT.
Disconnect this hose once installed and run Transmission overflow to back
and hose on the Cylinder towards front and down. See pics below
Engine is set up for PAIR Emissions System. PAIR is an acronym for Pulsed Secondary Air Injection System.
It is an emissions control system used to lower HC and CO emissions. It works by allowing air into the exhaust flow.
Please Read the Following Important Notices:
- This engine is shipped WET, included is 10/40 Motorex Oil and Transmission Fuild ALREADY INSTALLED. RECOMMENDED TO DRAIN OIL AND PUT .9 LITERS IN.
- .9 LITERS OF ENGINE OIL NO MORE NO LESS. IF ON RUCKUS DIPSTICK WILL NOT SHOW OIL ABOUT 1/2 OF TRANNY FLUID ON TRANNY SIDE.
- Check oil level after letting the engine idle for a few minutes, add additional oil if needed.
- GY6 125cc and 150cc engines come in different sizes. Please measure the physical size of your engine and compare to our specifications before ordering if not for Ruckus Swap. The difference is in the length of the rear swing arm. Different lengths have been made to accommodate different wheel sizes.
- For rear drum brakes only.
- THE RUCK SHOP has a no-return policy on all engines, barring manufacture defect or shipping damage.
Be the first to review “150cc 4 Stroke Long Case GY6 Motor Engine 11 pole”