SPECIAL BLACK EDITION This is the carb everyone is using on GY6 swaps on their ruckus. Great for your 170cc-200cc GY6 motor. Suggested settings: Run air screw all the way in then back out 1/2 turn. Pull Needle E clip and set on the lowest setting on the needle. May need to adjust needle height. Recommend 32 Idle jet and 115 or 120 main. Select either 28mm or 30mm
BE SURE YOU GET THE JETS Usually 32 or 35 Idle and 115 or 120 main.
Correct Slide Cable is needed.
The product that you are purchasing is designed and intended for closed course competition use only and is labeled as such, i.e. Yoshimura “RACE SERIES.” Yoshimura RACE SERIES , Carburetors, Intakes, or any other performance products are neither designed nor intended for use on PUBLIC ROADS or LAND. Such use is prohibited by Federal and State regulations. By Placing order and agreeing to the Terms and Conditions at CHECK OUT you acknowledge that the item being purchased is for racing only and this vehicle will never be used on public roads or land.
GY6 ANGLED Clocking Flange for GY6 Swap
Exhaust studs for GY6 150cc and Honda 49cc engine M6
GY6 11 coil POLE Stator AC
ALL IN ONE GY6 Manifold riser angled clocking flange 56mm V3 NO CUTTING PLASTICS
Performance 4-Stroke Air Filter
Aluminum Intake Manifold 30mm GY6
Main jet kit PWK Carburetor Keihin Polini Stage 6 OKO 10 jets 

















There are no reviews yet.