TRS Honda Ruckus 6″ Single Row Performance CREE LED Light Bar Headlight Conversion Kit
Comes with Power coated matte black brackets. NOT a 1 piece bracket. 2 piece bracket allows for better installation and bracket not warping. THIS is DC not AC, LED are DC always
WORKS ON BOTH GY6 AND HONDA RUCKUS SEE INSTALLATION INSTRUCTIONS
- Working Voltage 10-45v DC LED
- 6 PCS * 5W High Intensity Cree LED
- Lifespan: 50,000 hours
- Lumens 3000
- Color 6000K
- Optics: Spot Beam
- Dimensions: 6″ Single Row
- Material: Superior Military Grade Die-Cast
- Aluminum Housing with Heat Sink Extrusion and Poly Carbonate Lens
- CE approved
- RoHs Compliant
- Waterproof Rate: IP67
WE NOW OFFER BRACKET ONLY MUST USE UNDER 7.5″ LED CREE LIGHT BAR. WE ARE NOT RESPONSIBLE IF YOU DO NOT HAVE CORRECT LED BAR. NO HARDWARE INCLUDED . ALL SALES ARE FINAL ON BRACKETS ONLY . Our brackets are made in USA and powder coated in the USA.
Installation Instructions for Honda Ruckus :
You must run the LED Bar Red wire to a 12V DC (Direct Current) ignition source. You cannot run off AC stator if you do the headlights may pulse or blow after time. Using Volt meter find a12V power + power + and run to headlights since you do not have hi/LO beam, or Find 12V ignition power source to the Handlebar switch FEED wire. There are 3 wires for the headlight switch 12V feed and Hi / LO wires. Cut AC feed wire and Cap off. Now Y off the 12V + to the headlight switch feed. From there now hook up either the LED BAR Red wire + to either hi beam or low beam on the headlight harness. Hooking to Low beam wire your switch must be on low beam to run. If you switch to hi beam on the switch it will turn off. Take Black wire on LED bar to battery ground.
Using HONDA Ruckus Switch . The horn power is 12V ignition (black w/ Grey tracer) Y or split off that wire and cut the AC Feed wire to the headlights (blue w/ 2 gray tracers) . Cap off feed from harness and now connect the new 12v you split off the horn to the headlight switch feed wire. Do all of this after the plug about 2 inches so you can put back if needed. Take red wire off LED and hook to headlight harness either low or high beam and Black wire from LED bar to negative of battery. If none of this makes sense. PLEASE TAKE TO A TECHNICIAN. Best to have Volt meter.
Using ATR GY6 Harness.
Super simple unplug yellow wire on harness to left switch unit and plug in black wire 12V to the yellow wire on the switch side.
Electrical items are non-returnable, please check photos and specifications before ordering.
Please see our Warranty & Return Policy.