TRS GY6 ANGLED Clocking Flange for GY6 Swap

$35.99 $24.99

Running a forward facing carburetor, and having problems with how high the carburetor sits? Some carbs have a problem when angled too high in the front, and this can cause the engine to not run right, and have problems feeding fuel properly! Before…

In stock

- +
Compare
SKU: ANGLEDCLOCKFLG Categories: , Tag:
Running a forward facing carburetor, and having problems with how high the carburetor sits? Some carbs have a problem when angled too high in the front, and this can cause the engine to not run right, and have problems feeding fuel properly! Our clocking flange is flat with no engraving on top so you get a GOOD SEAL on the manifold O-Ring.
THE  ANGLED CLOCKING FLANGE INCLUDED IN OUR TRS GY6 EXTENSION MOUNT KIT. COMES WITH 3 SETS OF BOLT . 1 SET FOR THE HEAD AND 2 SETS DEPENDING ON MANIFOLD YOU ARE USING. AFTERMARKET 30MM ARE THICKER THAN STOCK .Before (Without Flange):
After (With Flange):
This flange also turns the carburetor in more to the center of the bike so that when running a fat tire setup, the carburetor doesn’t hit the frame, and when running a normal wheel, having the carburetor centered gives the bike a much nicer look… It also more importantly angles the carburetor down a bit so that the fuel can sit more level in the bowl, and you can have a much better running motor!YOUTUBE INSTALL VIDEO ON ANGLED AND ALL IN ONE CLOCKING FLANGE
  • Machined O-Ring Groove
  • CNC Machined 6061 Billet Aluminum
  • Includes Stainless Steel Hardware, and O-ring

 

Weight 0.1875 lbs
Dimensions 3 × 6 × 1 in

Reviews

There are no reviews yet.

Be the first to review “TRS GY6 ANGLED Clocking Flange for GY6 Swap”

Your email address will not be published. Required fields are marked *