In-Line Resistor for LED signals 10w 3 OHM

Corrects the fast-flash problem when using LED turn signals.
Simple splice in installation.
Sold in pairs – connectors included.
NO NEED TO BUY A LED FLASHER that May or MAY NOT work. Install these and your blinkers will work. Very small and they don’t get hot like the others.

These will work with any of the led lights that we sell in house. If you are putting this on your scooter and have leds from different companies you will have to check the wattage to make sure it will work.

Installation of Resistors: See pic Resistors connect the positive and negative of the turn signal to form H so to speak.  Only need 1 pair. Use Blue scotch connectors and squeeze hard with pliers in order for scotch connector to cut through wire insulation or you can solder.  One on the left front and one on Right front blinker. If you do not have front blinkers insert in the rear.