TRS Frame Extension Mount for Fatty Rim using Stock Ruckus Motor
In stock
$349.99
In stock
Ruckus GET FATTY FOR 8″ WHEEL conversion mount with 12.5 stretch. Allows you to run the 12×8, OR 10×8 Fatty rim.
Our mount is a SOLID piece of BILLET ALUMINUM 6061-T6 so it’s super strong. The center allows more room than other mounts so the choke and TPS sensor don’t get pinched. We also include 3 ft of fuel line. The TRS mount even has a hole so you can run the fuel line through it for that clean look.
The Kit comes with a 1/2 spacer and 2 x 1/4 spacer. Depending on your shock you can install the spacer to right of the shock or in the middle of the two 1/4 spacers as seen below.
| Weight | 6 lbs |
|---|---|
| Dimensions | 13 × 6 × 3 in |
Based on 0 reviews
Be the first to review “TRS Frame Extension Mount for Fatty Rim using Stock Ruckus Motor”
You may also like…
-
Chassis, Gy6 150cc, Ruckus, Ruckus Gy6 Swap Parts, Suspension/ Brakes, Suspension/ Brakes
Lowboy low down Short Shock Black or Chrome Adjustable for Ruckus & GY6
Chassis, Gy6 150cc, Ruckus, Ruckus Gy6 Swap Parts, Suspension/ Brakes, Suspension/ BrakesLowboy low down Short Shock Black or Chrome Adjustable for Ruckus & GY6
Honda Ruckus low sitting rear shock. Drop that Ruckus down to even lower and be the most slammed Ruck on your block with this black on black rear shock. Top=Eye Bottom=Clevis 235mm, eye to clevis See difference in picture compared to NCY shock
SKU: 1000-1293
Related products
-
49cc Honda Exhaust, Engine Performance, Gy6 150cc, Ruckus
Exhaust studs for GY6 150cc and Honda 49cc engine M6
49cc Honda Exhaust, Engine Performance, Gy6 150cc, RuckusExhaust studs for GY6 150cc and Honda 49cc engine M6
Exhaust studs for GY6 150cc/125cc,QMB139, & Honda 50cc engines . M6 can be used on both 49cc and 150cc gy6 . HONDA 49cc use 6mm and most stock gy6 use 6mm as well. Big Bore Heads usually use M8.
SKU: 148-118
There are no reviews yet.